r/evcharging
Tesla Wall charge suddenely died 2 months after warranty, so I frankensteined.
- upvotes
- 28
- comments
- 9
Post
Highlighted: the lines this signal was extracted from
So a couple of months ago, my wall charger died 2 months after warranty. Played around a bit and found the thermistor in the handle went bad registering 500 degree's. I tried the 10k resistor, but they firmware patched that. I was not going to pay tesla's insane $600. Thats assinine. So I went to my local electronics recycler and I asked him to call me if a tesla charger came in as they only offered money on the copper. 3 weeks later, I had 4 units that only cost my $60 and now I had to figure out what was all wrong with them. Turns out, Telsa seemingly designs them this way. I reached out to wall connector support and started checking serials, all were 1-5 months past warranty, all had 3 red flashes. I built a quick connector to hookup 240 and bench tested them. 1 - mcu problem2 - mcu problem3 - handle problem4 - handle problem All $0.12 issues, but made unfixable by firmware. So I started mating good cables to good mcu's now I have 2.5 tesla chargers in perfect working order, and maybe a third is the guy who called me this morning gets back to me and it is another MCU problem. If your tired of giving tesla money, post on FB for broken chargers, talk to your local electronics recycler, start fixing them. It literally takes 30 minutes to swap and you can find apps to tell you the voltage and output when connected (I know Tesla One does it, but there are quicker, better...
Keep reading with a free account
The rest of this post, and every signal for Tesla, is in your free account.